GYPROC ANTI-SAG CEILING SYSTEM

DARE TO FIX @600mm!

This fully concealed ceiling system comprises new innovative serrated Gypframe Eco metal profiles used in conjunction with two specially engineered ceiling boards designed for this system, fixings accessories and finishing products.

This fully concealed ceiling system comprises new innovative serrated Gypframe Eco metal profiles used in conjunction with two specially engineered ceiling boards designed for this system, fixings accessories and finishing products.

Key facts

  • Metal with serration technology for additional benefits
  • Increased secondary channel installation span - 600mm centres
  • Less material consumption
  • Reduced labour cost
  • Faster installation
  • Same framing for dry and wet areas

Application

A wide range of residential and commercial applications

Sector

Commercial
Education
Healthcare
Residential

Documents

gyproc_anti-sag_ceiling_system_brochure_-_technical_datasheet_-_2.1_edition_0
INSTALLATION OVERVIEW

 

Gypframe Eco Wall Angle is fixed to the wall at maximum 600mm centres using Gyproc Hammer Fix Anchor.

 

Secure Gypframe Soffit Cleat using Gyproc Wedge Anchor.

Gypframe Eco Main Channels are installed over the Gypframe Eco Wall Angles. Fix hangers (two per fixing) to Gypframe Eco Main Channel using Gyproc Waferhead Jack -Point Screws.

 

Extend Gypframe Eco Main Channels by overlapping back-to-back by 150mm minimum and fix together using two Gypframe Waferhead Jack-Point Screws.

 

Gypframe Eco Furring Channels are fixed to the underside of the Gypframe Eco Main Channels to form a grid with two Gyproc Waferhead Jack-Point Screws.

 

Gypframe Eco Furring Channel sections closely butted together with a further short (minimum 300mm) section of Gypframe Eco Furring Channel nested centrally over the joint and fixed using two Gyproc Waferhead Jack-Point Screws to each flange (8 screws in total) to reinforce the splice.

 

 

Gyproc boards are fixed to the secondary grid to form single or multi-layer linings as specified.

 

Board fixings for Gyproc boards should be at 150mm centres at board-ends, and at 230mm centres within the field of the board.