GYPTONE GRID
Gyptone GRID is a lightweight ceiling system available in concealed or exposed grid options. It presents an attractive pre-finished white ceiling possible by selecting the desired tile or plank edge profile.
Gyptone GRID is a lightweight ceiling system available in concealed or exposed grid options. It presents an attractive pre-finished white ceiling possible by selecting the desired tile or plank edge profile.
The ceiling void above the suspension grid can be used to route all service requirements including ducting, pipework, electrical cables, and conduits. Ducting, ventilation units, etc, must be independently supported from the structure.
Key facts
- Concealed or exposed grid options
- Attractive pre-finished white surface
- Wide range of ceiling tiles and planks giving smooth or perforated effect
- Provides sound attenuation and absorption
- Electrical and other services accommodated in plenum
- Will support loads up to 3kg per tile without a pattress
- Ceiling tile and plank site waste can be recycle
- Gyptone planks are available in bespoke sizes
- Pre-finished plank is available in smooth or perforated options
Application
Due to the design flexibility of this suspended ceiling system suitable for most internal drylining applications. The fully concealed grid can be used in conjunction with Gyproc plasterboards, Rigitone or Gyptone boards to create a seamless, monolithic appearance
Sector
Plank edge profile is fixed to the wall at 300mm centres. Reduce the Main ‘T’ sections by a maximum of 10mm, in relation to the width of the room or corridor and fit into Plank edge profile on the upper recessed flange.
There is no requirement to install hangers to support the Main ‘T’ sections. Main ‘T’ sections should not be joined.
No soffit supports / hangers required. Gyptone planks are located on the lower flange of the Plank edge profile. Corners and alcoves require specific detailing.
Plank edge profile is fixed to the wall at 300mm centres. Reduce the Main ‘T’ sections by a maximum of 10mm, in relation to the width of the room or corridor and fit into Plank edge profile on the upper recessed flange.
There is no requirement to install hangers to support the Main ‘T’ sections. Main ‘T’ sections should not be joined.
No soffit supports / hangers required. Gyptone planks are located on the lower flange of the Plank edge profile. Corners and alcoves require specific detailing.